Gerber P2C™ 1600 Cutters
User’s Manual
Operation
2-11
2.3.5 OVERCUT
The OVERCUT submenu enables you to establish an overcut to facilitate
weeding.
The default overcut value is 1.
The overcut setting can be disabled (=0) or set to any value between 0(=off)
and 10. One unit is about 0.1 mm or 0.004 ".
The current overcut value is marked with an asterisk (
!
) on the LCD.
2.3.6 POUNCING GAP
The pouncing gap submenu is used to set or modify the distance between the
pounced holes. Pouncing gap only applies when the machine is in pounce
mode.
The default pouncing gap is 1 mm.
The value can be set between 0 and 50 mm.
The current pouncing gap value is marked with an asterisk (
!
) on the LCD.
2.3.7 SYSTEM SETUP
The SYSTEM SETUP submenu includes menu items normally needed only during
initial setup when the cutter is made to communicate with the computer and
software.
Press the
key to access the different submenu items, which are explained
in section 2.4.
