Gerber P2C™ 1600 Cutters
User’s Manual
General Information
1-15
MAKE SURE THIS
IS CONNECTED TO A
MAKE SURE THIS IS
CONNECTED TO A
THREE-PIN
PLUG
EUROPE:
USA
OUTLET
:
THREE-PIN
KNOWN EARTH
KNOWN EARTH
FIGURE 1-3:
EARTH CONNECTION
!
IMPORTANT OPERATIONAL TIP
Your cutter must only be used with a power outlet that is properly
grounded to earth. Use of an unearthed outlet exposes the operator to
the risk of electric shock and will also lead to malfunctioning of the
cutter.
1.6.2. POWER UP PROCEDURE
!
!
!
!
To power up the cutter, proceed as follows:
1.
Be sure the cutter is securely attached to its stand.
2.
Plug one end of the AC power cord into the AC power cord receptacle
on the cutter's rear panel.
3.
Plug the other end of the AC power cord into the wall socket.
4.
Press the "I" side of the ON/OFF rocker switch on the rear panel to switch
the cutter ON.
5.
The message "INSERT MEDIA" is displayed on the LCD if no media is loaded
and the pinch rollers are in the up position.
