Gerber P2C™ 1600 Cutters
User’s Manual
General Information
1-24
FIGURE 1-10:
FEEDING ROLL MEDIA WITHOUT USING MEDIA FLANGES
4. Make sure that the media follows a straight path from the roll to the cutting
area. This can be accomplished by sliding the media guides left and right
as needed along the media support rollers.
5. The pinch rollers should be positioned over the drive sleeves and about 3 to
15 mm (0.1” to 0.6”) in from the edges of the media.
FIGURE 1-11
PINCH ROLLER POSITIONING
6. Raise the pinch roller lever to lower the rollers onto the media and drive
sleeves. The tool carriage will automatically begin moving left and right to
sense the usable media width.
