Advanced enVision Functions 53
4.
Press F3, DISABLE. You see a message that the test job has been disabled.
Press any key to return to the MAIN MENU.
The test job can also be disabled by turning the power off and then on.
X08 cut test
The X08 cut test also tests the X, Y, and Z axes. It requires a knife tool. Once
the job is enabled it will continue to be available until it is disabled. If the plotter
is in Single mode, it will cut one test pattern and stop. Another test pattern will
be immediately available, and Start-Job will be blinking. If the plotter is in Multi
mode, it will continuously cut the test pattern.
1.
Load vinyl.
2.
Load a knife tool in the tool head.
3.
Choose either Single mode or Multi mode on the MAIN MENU.
4.
Press F3 while holding down the ENTER key for the Operational Setup
menu.
5.
Press F2, TEST.
12'4#6+10#. 5'672
5GVVKPIU
5[UVGO
6GUV
/KUE
'06'4 HQT /CKP /GPW
(