Advanced enVision Functions 51
Wagon wheel test plot
The wagon wheel test plot is a pen plot and is used to check the X, Y, and, Z
axes. Once the job is enabled it will continue to be available until it is disabled.
If the plotter is in Single mode, it will plot one test pattern and stop. Another test
pattern will be immediately available and Start-Job will be blinking. If the
plotter is in Multi mode, it will continuously plot the test pattern.
CAUTION: Do not run this job with a knife installed. Install the pen.
1.
Load material in the plotter for pen plotting.
2.
Make sure that a pen tool is loaded in the tool head.
3.
Choose either Single mode or Multi mode on the MAIN MENU.
4.
Press F3 while holding down the ENTER key for the Operation Setup
menu.
5.
Press F2, TEST.
6.
Press F1, TEST JOBS.
(
12'4#6+10#. 5'672
5GVVKPIU
5[UVGO
6GUV
/KUE
'06'4 HQT /CKP /GPW
(
6'56 /'07
6GUV ,QDU
/GOQT[
%CNKDTCVG
#ZKU
'06'4 HQT /CKP /GPW