24 enVision Owner’s Guide
Note: If you press F1 before sending the job, it starts immediately when
received by the plotter. In this case, you must load the material and install
the tool before you send the jobs to the plotter. (See “Running multiple jobs
automatically” on page 25.) This feature is convenient if the plotter is in a
remote location separate from the computer.
3.
Press F4, HOME to rotate the three closely-spaced alignment pins to the top
for easy material loading.
4.
Load the material and install the tool in the plotter.
Note: Using the left and right slew keys to move the tool head near the
center may make it easier to load the material.
5.
Use the slew keys to position the tool where you would like plotting to
begin.
6.
Press F1, Start-Job to begin plotting the first job. Subsequent jobs will not
require pressing Start-Job again.
Note: In Multi mode, the job/color/type display is bypassed even if the
Plotter Prompts check box is turned on.
While the job is running, you can press F1 to pause the job, and F1 again to
restart it just like in Single mode. Job Status alternately displays
4WPPKPI
and
the percent done (GA version 6.2 only). When the jobs are plotted, the Job
Status remains at
4WPPKPI
and Mode remains set to
/WNVK
. If you send another
job to the plotter, it will begin plotting immediately.
/#+0 /'07
Pause-Job
5GVVKPIU
/QFG /WNVK
*QOG
,QD 5VCVWU
4WPPKPI
(
/#+0 /'07
5VCTV,QD
5GVVKPIU
/QFG /WNVK
*QOG
,QD 5VCVWU
4GCF[