Plotting Jobs 23
7.
The plotter displays the vinyl type and color required by the job. This
information enables you to verify that you have the correct material loaded
for the job. This screen only appears if you are using GA version 6.2 and
the Plotter Prompts checkbox turned on.
8.
Press F4.
The job starts and Job Status alternately displays
4WPPKPI
and the percent done
(GA version 6.2 only). While the job is running, you can press F1 to pause it and
F1 to re-start it again.
Note: The cover must be closed for the job to run.
After completing the job, the Job Status returns to
0Q ,QD
. If you have sent
several jobs, the Job Status displays
4GCF[
and you will need to press F1,
Start-Job to plot each job.
Plotting multiple jobs
Multi mode lets you plot several jobs without having to press Start-Job between
each one. When one job finishes plotting, the next job begins immediately.
When all jobs in memory are plotted, the enVision waits for another job and will
plot it as soon as it is received. Multi mode is best used for jobs that require the
same material.
1.
Press F2 to switch between Single mode and Multi mode. Choose
/WNVK
.
2.
Send the jobs from your computer to the plotter. When the jobs are received
in the plotter’s memory the Job Status changes from
0Q ,QD
to
4GCF[
and
5VCTV,QD
blinks (indicated by the dotted box around Start-Job).
Job:
→
PLT1474.TMP
Color: White
Type: 220
Press F4
(
/#+0 /'07
5VCTV,QD
5GVVKPIU
/QFG /WNVK
*QOG
,QD 5VCVWU
4GCF[
/#+0 /'07
2CWUG,QD
5GVVKPIU
/QFG 5KPING
,QD 5VCVWU
4WPPKPI
(