Operator Manual
Programming
3.21
© Genmega 2011
3.3.6.5 CDU SETUP
The CDU (Cash Dispensing Unit) or Dispenser contains programming relative to its application
and country of destination. This programming does not need to be altered, however in the event
that the dispenser looses its factory programming the CDU Setup application can correct any
problems. NOTE: Incorrect programming of the dispenser will cause the machine to go out of
service.
Country Setting
: Set to USA or Canada
Cassette Number
: Set to 1 or 2 depending on number of cassette
CDU Type
:
CDU Model
Set CDU Type
TCDU / SCDU
Front Loader 1K
MCDU / HCDU
Front Loader 2K
Rear Load MCDU
Rear Loader 2K (*not available on G2500)
De La Rue
SDD with S/M
Teanam GBM
Puloon
LCDM1000
Configuring Dispenser
:
Once the settings are correct, then press ‘Apply’ to configure the dispenser.
If you get the error ‘No Comm’ or CDNxx, it means that either the settings are incorrect for the
dispenser type (for example if you try to program a SCDU as a De La Rue SDD, it will not work)
or if there is a problem with the cables that connect the dispenser to the main control board.
Note: Installing different dispensers may require additional hardware, check with Support before
installing if you are unsure.
