Operator Manual
Master Key Installation
C.1
© Genmega 2012
APPENDIX C: Master Key Installation
Master Key Installation
Master keys are entered only through an approved EPP (Encrypting Pin Pad) device and are stored in
the keypad. These keys, along with another key downloaded from your processor are used to encrypt
the ‘PIN’ numbers for customer transactions.
Two Passwords (Secure Mode Passwords) are required in order to enter ‘Key Mode’ and change any
options.
NOTE
: You will NOT be able to enter keys or change key mode until the Secure Mode Passwords
have been changed from default. After changing both passwords, you must back out of the operator
menu and reinitialize the ATM.
Please follow the procedures below to begin this process.
Installation Procedure:
To access the Key Management menu from Host Setup, you’ll need to enter the Secure Mode
Password (parts 1 and 2). See page 3.6 for Secure Mode instructions.
Default Secure Mode password is:
Part #1 = 000000 / Part #2 = 000000
Access the Key Mode selections by entering the
operator function menu
[ENTER]+[CLEAR]+[CANCEL] + 1 + 2 + 3
Enter Master Password and choose Host Setup
Note:
Master Password is required to access Key
Management Menu.
NOTE
: You must change the Secure Mode Password from default before any changes can be made
to Key Management, or enter any keys. Change the default passwords for Part #1 and Part #2 and
then completely exit the Operator Menu (cancel out and let machine initialize) Once you go back in
and use the new Secure Mode Passwords, you’ll be able to make changes or enter keys.
