English
-
42
-
Maintenance
1. Reboot system
The
“Reboot”
button will reboot the Network Camera. It’s useful if the Network Camera has a
problem.
2. Factory default
Click on Factory default button on the configuration page to restore the factory default settings.
Any changes made so far will be lost and the system will be reset to the initial factory settings.
The system will restart and require the installer program to set up the network again.
3. Calibrate
Recalibrate the home position to the default center to recover the tolerance caused by some
external forces. Note that there is no confirming message box after clicking on the
“Calibrate”
button, the Network Camera will calibrate immediately.
4. Upgrade firmware
Select the firmware file and click upgrade button. Be aware that you should not turn off the power
during updating the firmware and wait for the finish message.
NOTE
1. Warning: The upgrade firmware procedure cannot be interrupted. If the power and/or network
connection are broken during the procedure, it might possibly cause serious damage to the
Network Camera.
2. When updating the firmware, wait for 90~180 seconds, and then you can connect to the
Network Camera again. The system will restart and require the installer program to set up the
network again.
Summary of Contents for IPCam 350TR
Page 1: ...English IPCam 350TR Pan Tilt Infared LED User s Manual Version 1 0 ...
Page 14: ...English 14 ...
Page 15: ...English 15 ...