Genie Z-22 Bi-Energy, Service And Repair Manual

Page: 54 / 123

Service and Repair Manual September 2015
Generator
42 Z-34/22 Bi-Energy Part No. 1268515
Generator
7-1 Generator Pull ey 7-1
Generator Pulley
How to R emove the Generator Pull ey How to Remove the Generator
Pulley
1 Loosen the tension adjustment bolt on the
generator.
2 Push the generator towards the machine and
remove the belts from the generator pulley.
3 Remove the generator pulley retaining nut
from the generator shaft.
4 Slide the pulley off of the generator shaft.
5 Loosen the set screw on the pulley bushing,
then slide the pulley bushing off of the
generator shaft.
1 gap
2 shaft
3 set screw
4 engine drive pulley
5 engine drive pulley bolt
6 shaft bushing
7 woodruff key
How to Install the Generator Pull ey
How to Install the Generator
Pulley
Note: The pulley on the generator must be
installed before installing the engine drive pulley.
1 Align the woodruff key on the generator shaft
with the slot in the pulley and slide the pulley
all the way onto the generator shaft.
2 Install the flat washer and pulley retaining nut
onto the generator shaft, then torque the nut
to specification. Refer to Specifications,
Generator.
3 Adjust the tension of the generator belts.
Refer to Repair Procedure, How to Adjust the
Generator Belts.