User Manual
IP65 200m Analogue Wireless RF Data Transceiver
13
Listed below are the LED states for the data channel protocol.
6.6 Input Channels 1 & 2 - Transmit Pairing Signal
When input channels 1 or 2 are flashing, The RF200D is in “Send Pairing Signal” mode. By
briefly pressing the right button the signal LED’s will flash a TX signal (flashing from middle
outwards) to send the pairing signal to another RF200D device. The receiving device will
flash its signal LED 6 to indicate the reception.
6.7 Input Channels 1 & 2 - Set Input Mode
Four possible modes are available (see Hardware Description) and are listed.
6.8 Input Channels 1 & 2 - Internal Input To Output Pairing
The RF200D has an option to pair its own input to its own output. One good reason for
doing this is to use the RF200D as a timer but still transmit its status to other units. You can
only pair input 1 to output 1 or input 2 to output 2. The options are:
