11
6.0 RF200D Programming
The RF200D is configured by a software menu system using the status and signal LED’s to
show the currently selected options. When in configuration mode the currently selected
option is shown by one or more LED’s pulsing twice and the currently selected parameter
shown by one or more of the signal LED’s 1 - 4.
To Enter configuration mode hold down switches 1 & 2 for 3 seconds. Once 3 seconds have
elapsed all the RF200D’s LED’s flash 3 times. While in configuration mode, switches 1 - 3
work as follows:
• Switch 1 changes the current menu’s option.
• Switch 2 changes the currently selected parameter.
• Pressing switch 1 for three seconds saves all the new settings, flashes all of the RF200D
LED’s twice and reboots the system.
• Pressing the tamper switch for five seconds exits configuration mode and switches off
all LED’s without saving new settings.
6.1 RF200D Pairing Example
The RF200D follows the same procedure for pairing any input to an output including
the data channel and repeat mode. Listed below is an example to demonstrate how to
pair a single input to an output. The following pages in this manual describe the other
configuration modes for pairing the remaining peripherals.
To pair an input to an output is as follows:
1. Place both RF200D’s in configuration mode
2. Select an output channel to pair (first RF200D)
3. Select an input channel you wish to pair from (second RF200D)
4. On the second RF200D press the right button. The first RF200D’s signal LED 6 should
flash twice and the signal LED’s 1-5 should increment.
5. Save configuration by holding down switch 1 for three seconds
6. Test the connection by pressing the input channel switch for half a second and make
sure the second box responds.
7. Pairing complete!
6.2 Data Channel - Pairing
In this mode, briefly pressing the right switch of the RF200D transmits a pairing signal to
another device. If the RF200D receives a pairing signal from another device, signal LED6
flashes twice and the bottom 5 signal LED’s will increment.
1. Holding down the right switch for longer than 3 seconds clears any previously paired
devices from this channel. It’s only possible to pair a data channel with another data
channel. Listed below are the LED states for data channel pairing.
