User Manual
IP65 200m Analogue Wireless RF Data Transceiver
15
6.12 Output Channels 1 & 2 - Relay Test
The RF200D has a build in relay test function. When the output and signal LED’s 5 & 6 are
flashing, pressing the right switch will turn on the outputs relay and signal LED 1.
6.13 Tamper Output / 3rd Channel - Overview
The tamper channel can work as a tamper relay or a third channel. Pairing the tamper
channel to any local or remote tamper functions automatically configures the third
channel’s output into tamper mode. In tamper mode the relay is permanently energised
while no tamper fault has been detected. This is a fail safe system to prevent a power
failure not showing as a tamper fault. Setting any of the following configures the third
channel as a tamper channel:
1. Enable local tamper switch
2. Enable missing status updates
3. Pair any remote RF200D’s tamper channel.
It’s also possible to pair a standard input from a remote RF200D to the tamper channel.
A standard input from a remote RF200D will not switch the third channel into a tamper
channel, but it can be used as another tamper input. When a remote input is being used
on a tamper channel, triggering the input switches off the tamper relay, i.e. the signal is
inverted. This can be a useful feature if you wish to report back a remote tamper state from
a bell box or PIR etc.
If none of the above have been enabled or paired, the tamper relay works as a third
channel. In this mode the normal state is ‘Normally Open’. The only supported mode for this
channel is momentary.
Note:
When the local tamper switch is disabled, its status is still transmitted to
other RF200D devices.
6.14 Tamper / Third Channel - Pairing
In this mode, briefly pressing the right switch of the RF200D transmits a pairing signal to
another device. If the RF200D receives a pairing signal from another device, signal LED6
flashes twice and the bottom five signal LED’s will increment by 1. Holding down the right
switch for more than 3 seconds clears any previously paired devices from this channel. It
is only possible to pair a data channel with another data channel. Listed below are the LED
states for the data channel pairing.
