User Manual
IP65 200m Analogue Wireless RF Data Transceiver
17
6.19 Repeat Mode - Pairing
In this mode, briefly pressing the right switch of the RF200D transmits a pairing signal to
another device. If the RF200D receives a pairing signal from another device, signal LED
6 flashes twice and the bottom five signal LED’s will increment. Holding down the right
switch for more than three seconds clears any previously paired devices from this channel.
When pairing a RF200D repeat, all functions from the RF200D will be repeated. Up to five
RF200D units can be repeated. Listed below are the LED states for repeat mode pairing.
6.20 RF Channel Selection
The RF200D has 7 RF channels and defaults to channel 5. Below is a list of all
the channel numbers and their corresponding frequencies:
6.21 Restore Factory Settings
This option resets the RF200D back to factory default and erases any previously paired
devices. When selected all the status LED’s flash together
To reset the RF200D, hold down the right switch and wait for the signal LED’s to increment
from 1 to 6, this is a warning stating all settings are about to be erased.
When the 6th LED is on there will be a short pause followed by the RF200D flashing all its
LED’s before rebooting.
Once the RF200D has rebooted it will have restored its factory defaults and erased any
previously paired devices.
