Genesis COUPE BK 2010, Manual

Page: 78 / 168

After a repair, it is essential to verify that the fault has been corrected.
5. Does "INPUT & OUTPUT SPEED SENSOR" within specifications?
ُ Go to "Component Inspection" procedure.
ُ Check for electrical niose of circuit in INPUT & OUTPUT SPEED SENSOR or Replace INPUT &
OUTPUT SPEED SENSOR. Repair as necessary and Go to "verification of vehicle repair" procedure.
Component Inspection
1. Connect GDS.
2. Engine "ON" .
3. Monitor the "OIL PRESSURE. S/W 1,2,3,5,6" parameter on the GDS.
4. Move select lever to "D" range and operate vehicle within 4th gear condition.
5. Does "OIL PRESSURE. S/W 1,2,3,5,6 " follow the reference data?
ُ Repair AUTO TRANSAXLE(Clutch or Brake) as necessary and Go to "verification of vehicle repair"
Repair " procedure.
ُ Replace AUTO TRANSAXLE (BODY CONTROL VALVE faulty) as necessary and Go to "verification
of vehicle repair " procedure.
Verification of Vehicle Repair
1. Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
2. Using a GDS, Clear DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTCs present ?
ُ Go to the applicable troubleshooting procedure.