Genesis COUPE BK 2010, Manual

Page: 38 / 168

The Input Sensor of RXC Auto transmission is composed of S1(Sensor1) and S2(Sensor2). S1 inputs signal to TCM only at
4th gear and S2 does at 1st, 2nd, 3rd, 4th and 5th gear.
Therefore, sensing pulse frequency outputted from sensor 2, TCM calculates Inputshaft speed and compute Turbine rotation..
This value is mainly used to control the optimum fluid pressure during shifting.
The TCM sets this code if an output pulse-signal is not detected, from the INPUT SPEED SENSOR 1 or 2, when the vehicle is
running faster than 24.85MPH(40km/h). The Fail-Safe function will be set by the TCM if this code is detected.
GENESIS COUPE(BK) >2010 > G 2.0 DOHC > Automatic Transmission System > Automatic
Transmission System > P0716 Input/Turbine Speed Sensor \'A\' Circuit Range/Performance
Component Location
General Description
DTC Description
DTC Detecting Condition
Item Detecting Condition Possible Cause
DTC Strategy • Speed range & Rationality
Enable
Conditions
Case 1(Too
High)
• Battery Voltage >10V
• Open or short in signal circuit
• Open in power circuit
• Open in ground ircuit
• Faulty input speed sensor 1or 2
• Faulty TCM
Case 2
(Rationality)
• Battery Voltage >10V
• The time after the last shift was finished > 500msec.
• Output Speed > 200RPM
• Engine Speed > 700RPM
Threshold
Value
Case 1(Too
High)
• Input speed 1 >= 10000rpm or Input speed 2 >=
10000rpm
Case 2
(Rationality)
• Input speed 1(1,2,3,5th gear) > 100rpm
Diagnostic Time • More than 2sec.
Fail Safe
• Nt(Turbine speed 1) : fixed as 600rpm
• Sports mode Inhibition
• 5th gear Shifting Inhibition
• Inhibition of pressure adaptation
• Torque Conveter Clutch : OFF
Specification
NAME T01-3 PIN No. Measurement Condition Spec.
Turbine Sensor 1 6
• 1st gear
• 20km/h
• IDLE S/W OFF