Date: 2021-08-17
Copyright of the European Union is effective (Copyright EU) (c) 2021 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL [email protected] - WEB www.generex.de (This and all other product datasheets are available for download.)
20
Review
Check data before you finish the configuration process before finishing.
Note:
The Setup Wizard simply summarizes basic settings and provides a quick and convenient solution that can be used to make or
change basic settings. If you want to perform the configuration completely manually, click here Cancel - You can always restart
the Setup Wizard in the configuration menu.
But be careful:
Some entries such as UPS configuration have dependencies to
advanced configuration entries the Wizard does not include.
Configuration mode: Basic settings
For this configuration step, navigate to the following menu
Most settings can be done as long as the CS141 is in configuration mode. Depending on your network settings there could be a
problem when performing tests and forwarding functions - they are often not possible on hardware pre-set 10.10.10.10.
Due to
this fact it is a good choice to configure all basic settings inside configuration mode and switch to normal mode before starting
advanced UPS configuration.
To configure system’s network configuration, open
Network:
Under Configure, enter the IP address data the system shall use. Active shows the current IP address settings used by the
system.
It is possible to change the following settings
On first start-up, the CS141 will get hard-coded information. The required IP address information to enter the operational mode
correctly can be obtained by contacting the responsible network administrator.
Press Apply to save your settings.
Note:
At this point, the web browser redirects you to the new IP address. Since the CS141 is still in configuration mode, you will
receive an error message from your web browser. In this case, ensure to work with the IP 10.10.10.10 and press CTRL F5 to
refresh the web browser.
For a first configuration, the Network menu is the only setting you currently need to make in Configuration mode.
