The Web Interface
SC-IP Web Screens
4-8
SpectraComm IP Router Card
076R200-000
Installation and Operation Manual
Issue 2
IP Static Route Web Screen
The IP Static Route Configuration screen displays a read-only list all entered destination devices or
networks and their static routing attributes. Information displayed on this is compiled from data
entered at the command line interface or derived from the IP address and mask. For more
information, refer to Chapter 3:
Configuring SC-IP with Smart CLI
, or use the CLI online help
provided at the Command Line web screen.
Table 4-6
IP Route Configuration Screen
Field
Description
IP Address/
Prefix
Displays the IP address configured for destination devices, networks or interfaces.
Next Hop/GW
Displays the configured IP address of the next hop or gateway address that must be used
to forward the packet out the corresponding 'interface.'
Metric
Displays the value (0-255) used by the router to determine the 'cost' of using the route. If
a destination can be reached by two or more routes, the one with the lowest cost is used.
Interface
Specifies which logical port will be used to forward the received IP packet:
ethernet0 (LAN port),
serial0 (T1port) or serial0.
nnn (DLCI nnn on T1 port)
serial1 (synchronous DTE port) or serial1.
nnn (DLCI nnn on T1 port)
modem0 (modem port)
Line Protocol
Displays the Layer 2 protocol for the interface (UP or DOWN).
Type
Displays the type of route.
Summary of Contents for SC-IP
Page 1: ...6SHFWUD RPP 3 ROUTER CARD Installation Operation Manual 076R200 000 Issue 2 October 2002...
Page 89: ......
Page 90: ......