SC-IP Configuration
Configuring SC-IP with Smart CLI
3-8
SpectraComm IP Router Card
076R200-000
Installation and Operation Manual
Issue 2
9. Describe and enable the interface by typing:
configure interface description
[your_decription]
configure interface enable serial0
Note
Type
show interfaces
to check your interface entries. Modify, if needed.
10. Configure Terminal Server Ports 1 through 8 as needed by typing:
configure term-serv ip-address term
[#]
[###.###.###.###]
configure term-serv description term
[#]
[your_description]
11. Enable each configured Terminal Server Ports by typing:
configure term-serv enable term
[#]
12. Set up static routes for the PPP (leased line) network by typing:
configure ip-route add serial0
[destination IP] [destination mask]
[next hop/gateway] [metric]
Note
When setting up static routes, type the short-cut
conf ip a ?
to get a list of all required arguments.
13. You have completed the configuration of the SC-IP for a Frame Relay DTE network
environment. You can check your settings with the following two techniques:
•
Type
show config
to display the current configuration of the SC-IP.
•
Test your example network by pinging from your PC/workstation at the NOC to
equipment at the remote office, and vice-versa.
Summary of Contents for SC-IP
Page 1: ...6SHFWUD RPP 3 ROUTER CARD Installation Operation Manual 076R200 000 Issue 2 October 2002...
Page 89: ......
Page 90: ......