Installation Instructions
Step 1. Remove the Stainless Steel Reactor Chamber (A) from the box.
Step 2. Remove the end Cap(B) from of the Stainless Steel Reactor
Chamber
Step 3. Take out the Silicone Stopper (C) and Quartz Sleeve (E) from the
packaging.
Step 4.Attach the Silicone Stopper (C) to Quartz Sleeve(E).
Step 5.Place the Stainless Steel Reactor Chamber vertically. Very carefully,
slide the Quartz Sleeve into the Chamber until it fits (*) into the bottom
opening and goes through it. The bottom end should contain the same
amount of visible glass as another side of the Chamber.
Step 6. Screw the end Cap (B) onto the Stainless Steel Chamber (A). It will
keep the Sleeve in place and prevent it from sliding.Hand-tighten both
Caps, do not use any tools!!!
Step 7. Carefully take out the UV Lamp
(F) from packaging. Do not touch the
glass! Use the ceramic end of the Lamp.
If you touched the glass, make sure you
clean it off with glass cleaner. Do not use
oils, as it will cause spots and premature
bulb failure.
6
www.geekpure.cc
