48
Y Series TechBook
Feed the cable of the new
keypad through the hole
opening in the spa
Orient the cable's
connector towards the
spa pack to facilitate its
connection later
Insert the keypad in the
opening
Peel off the protective
layer from the adhesif on
the back of the keypad
Make sure that the keypad
is well aligned and rests
perfectly in the recess of
the spa
With a scraper tool, gently
clean the installation
surface of the new
keypad, then use an
alcohol saturated paper
towel to remove any
unwanted residue left
over from the old keypad
Place a rubber 2" O-ring
gasket at the end of each
heater nut, to prevent
water leakage between
the heater nuts and the 2”
PVC heater tailpieces
When installing the new
spa pack, slide the back
side of the unit's feet into
the guide plate
Install the new spa pack in
the spa plumbing
Secure the keypad in
place Ensure that its
adhesive strip is properly
glued by pressing evenly
with your finger over the
entire surface
Screw fittings to join to the
spa pipe system, making
sure that the piping and
nut threads are not over
tightened
Use an open-ended
wrench to tighten both 2"
plastic nuts at each end of
the unit's heater
Finally, reopen both flow
shut off valves and verify
for leaks
