Y Series TechBook
27
Up/Down key
Use
Up
or
Down
key
to set desired water
temperature The
temperature setting will
be displayed for 5 seconds
to confirm your new
selection
The
Set Point
indicator
indicates that the
display shows the
desired temperature,
NOT the current water
temperature!
98
Programming the system
Depending on system
configuration the system
performs either purge
cycles or filter cycles
Programming filter cycles
To program the filter
cycles, you must enter the
duration and frequency
During a filter cycle,
pumps & blower run
at high speed for one
minute to purge the
plumbing Pump 1 or CP
then runs at low speed for
the remainder of
the cycle
Setting filter cycle duration
Press and hold
Prog
or
Light
key until the display
shows
dxx
, with "
xx
"
representing the duration
in hours
Use
Up
or
Down
key to
change setting
0 = no filtration
24 = continuous filtration
Note: it's not recommended
to set this to "0".
Off Mode
This mode allows you
to stop all outputs for
30 minutes to perform a
quick spa maintenance
Press and hold
Key 1
for
5 sec to activate the Off
mode Quick press
Key 1
to reactivate the system
before the expiration of
the 30 minute delay
While the Off mode is
engaged, the display will
toggle between
OFF
and
the water temperature
Programming purge
cycles
To program the purge
cycles, you must select the
frequency During a purge
cycle, all pumps and
the blower run for one
minute
Purge cycle frequency
Press and hold
Light
key
until the display shows Fx,
with "x" representing the
number of purge cycles
per day (up to 4)
Use
Up
or
Down
key to
change setting
When the desired
setting is displayed, press
Light
key to confirm
A purge cycle will start
immediately
The
Filter
indicator lights
up when a purge cycle
is on
F 2
Setting the temperature
display units
Quick press
Light
key
again
The display will show
either
°F
or
°C
Use
Up
or
Down
key to
change units
Press
Light
key a last time
to go back to normal
mode
°F
= Fahrenheit
°C
= Celsius
Filter cycle frequency
Press
Prog
or
Light
key
again
The display will show
Fx
,
with "
x
" representing the
number of filter cycles
per day (up to 4)
Use
Up
or
Down
key to
change setting
When the desired
setting is displayed, press
Light
key to confirm
A filter cycle will start
immediately
The
Filter
indicator lights
up when a filter cycle is on
F 2
