8
Y Series TechBook
The following material
is recommended:
4- # 10 screws of
appropriate length with
round, truss or pan
head
4- washers 1/2” OD x
1/16” thickness (12 mm
OD x15 mm)
Select the most
appropriate location on
the floor for the spa pack
and firmly attach the 2 rear
feet to the wooden base
using 2 screws backed by
2 washers
Note: The spa pack must be
installed at least 4" (52 mm)
above potential flood level.
If floor is on ground level,
pack should be raised at least
4" (52 mm).
Important!
Please note that
countersunk screws
should not be used as
they can damage the
power box support
Now firmly attach the front
feet of the pack to the
wooden floor using
2 more screws backed
by 2 washers
4"
Floor installation procedure without guide plate
Warning!
Beware the application of some products commonly used against corrosion
(such as WD-40 family products) as they could damage the power box, due to
a negative chemical reaction between some industrial oils and its plastic
enclosure Any other materials which may come in contact with the enclosure
must be carefully evaluated under end use conditions for compatibility
The following material is
recommended:
4- # 10 screws of
appropriate length with
round, truss or pan
head
4- washers 1/2" OD x
1/16” thickness (12 mm
OD x 15 mm)
Use 2 standard 2x4
or 2x6 wall studs, spaced
on 17-inch centers to affix
the spa pack
Firmly attach lower
mounting holes on each
side of the pack with the
2 remaining screws and 2
washers Lower mounting
holes are 2" (51mm) below
upper holes
Firmly attach, one at a
time, upper mounting
holes on each side of the
spa pack with 2 screws
backed by 2 washers
Install mounting brackets
on both sides of rear of
unit, using the screws
provided with the bracket
Wall installation procedure with optional wall mounting brackets
