3.
Fix the proximity switch holder in position with the countersunk screw (3).
Fig.54
®
Done.
Fitting the proximity switch
Carry out the following steps:
1.
Remove the adjusting screw (6).
2.
2. Screw the proximity switch M12 (8), together with the lock nut (11), into the
holder as far as the balancer (7).
Fig.55
®
Done.
Adjusting the proximity switch
Carry out the following steps:
1.
Unscrew the proximity switch by one full turn (360°) to set a gap (a) in the
range from 0.5 to 1.0 mm.
Fig.56
2.
Tighten the lock nut (11).
3.
Secure the connector (10), which has already been electrically connected to
the control top, to the proximity switch using the cap nut M12 (10.1).
Start-up
Adjusting the Proximity Switch in the lantern of PMO Valve Type M/2.0
430BAL010699EN_6
74
17.03.2022
Summary of Contents for T.VIS A-15
Page 6: ...430BAL010699EN_6 6 17 03 2022...
Page 116: ......