GE VP11, Reference Manual

Page: 49 / 118

Table 7: VMEbus connector P0 with partial I/O, HD interface, SATA, Audio
a b c d e f
1 GND GND GND GND GND GND
2 LPA_DA- GND LPA_DC- GND
3 LPA_DB- GND LPA_DD- GND
4 LPB_DA- GND LPB_DC- GND
5 LPB_DB- GND LPB_DD- GND
6 \M1ACT \M2ACT +3.3V_SW
1)
\M1LINK \M2LINK GND
7 SATA_TX0 \SATA_TX0 PMC2IO03 PMC2IO02 LINE_INL GND
8 SATA_RX0 \SATA_RX0 PMC2IO08 PMC2IO07 LINE_INR GND
9 SATA_TX1 \SATA_TX1 PMC2IO13 PMC2IO12 PMC2IO11 GND
10 SATA_RX1 \SATA_RX1 PMC2IO18 PMC2IO17 AGND GND
11 CD_INL
CD_INR PMC2IO23 PMC2IO22 HP_OUTL GND
12 CD_GND SPDIF_OUT PMC2IO28 PMC2IO27 HP_OUTR GND
13 PHD06
PHD08 PHD07 PMC2IO32 \PHD_RST GND
14 PHD11 PHD04 PHD10 PHD05 PHD09 GND
15 PHD01 PHD13 PHD02 PHD12 PHD03 GND
16 PMC2IO50 PMC2IO49 PHD15 PHD00 PHD14 GND
17 \PHD_DACK \PHD_IORDY \PHD_IOR \PHD_IOW PHD_DRQ GND
18 PHD_A2
PHD_A0 PHD_ATA PHD_A1 IRQ14 GND
19 N.C. \PHD_CS1 \PHD_CS0 PMC2IO62 PMC2IO61 GND
Signal groups:
PMC I/O signals:
PM2CIO_...
Gigabit Ethernet LPA_… and LPB_…
Serial ATA SATA_... and \SATA_...
Note:
1)
+3.3V_SW switched-on after ramp-up. This is the only 3.3 VDC source for
the Transition Module VTM22. Do not connect the +3.3V_SW pin to +3.3 V
pins; damage may occur.
Important note:
In this configuration only the following PMC I/O signals are available:
PMC I/O02, 03,07, 08, 11, 12, 13, 17, 18, 22, 23, 27, 28, 32, 49, 50, 61, 62.
VMEbus Connector P0 (P7300) with full PMC-I/O
Note:
The LAN pin assignment is compliant to the VITA 31.1 specification 'Gigabit
Ethernet on VME64x Backplanes'.
GE Intelligent Platforms – VR11, VP11 Hardware Reference Manual, Second Edition Page 49