GE VP11, Reference Manual

Page: 23 / 118

Audio codec
Line In, CD In, SPDIF out, headphone
AC97 link with codec
VGA and DVI
ATI Mobile X300 controller, 1280 x 1024, rear DVI-I up to 1280 x 1024, 32
MB RAM
256 bit 3D & 2D graphics accelerator, on-chip up to 32 MB frame buffer
PCIe x4 interface
Single channel DVI-I PanelLink for TFTs up to 1280 x 1024
Front I/O not with conduction cooled style 8
Gigabit Ethernet (GigE)
Two 10/100/1000BaseT Ethernet channels (with x4 PCIe interface) either front
(not with conduction cooled style 8) or rear, compliant to ANSI/VITA 31.1-
2003
Fast Ethernet
One front channel (not with conduction cooled style 8), 10/100BaseT
SATA
Two SATA, RAID 0/1 capable
EIDE/ATAPI
UDMA 100 EIDE/ATAPI interface with two IDE channels
secondary IDE (ATA 33) onboard and primary IDE rear
transfer rate up to 100 MB/s or 16 MB/s in PIO mode 4 and bus master IDE
for two external devices and one onboard 2.5” hard/flash disk.
Important note:
The primary IDE signals are shared with some PMC2IO signals.
The primary IDE is only available in the configuration with partial PMC-IO or
without PMC2. In the configuration with partial PMC-IO PMC2IO31 to
PMC2IO60, PMC2IO63 and PMC2IO64 are not available.
Make sure, that the PMC-IO pins on the PMC-module don’t conflict with the
IDE-signals!
Floppy
Via USB
Serial I/O
Two asynchronous 16550 compatible full duplex channels with 16 byte FIFO at
rear I/O, transfer rates up to 115.2 KBaud, user selectable RS232/422/485 in
BIOS setup.
COM1 (
only RS232
) optionally available at front (not with conduction cooling
style 8)
Important note:
On the front panel there is an RJ45 type connector for COM1 signals. This
limits the front panel connector to RS232 operation (without Ring Indicator).
RS422/485 can only be used with rear panel connectors
GE Intelligent Platforms – VR11, VP11 Hardware Reference Manual, Second Edition Page 23