– 29 –
Evaporator
To remove the condenser:
Unplug the ice maker or disconnect the power.
1.
Note:
If unit has handle attached to top of door it
must be removed to access hinge screw.
Remove the top door screw from the icemaker
2.
door, and pull the door off the bottom hinge.
Remove the ice from the storage bin.
3.
Remove the cutter grid and the evaporator
4.
thermistor from the unit. (See
Cutter Grid
and
Evaporator Thermistor
.)
Disconnect the bin thermistor connector from
5.
the bottom of the control housing.
Remove the two 5/16-in. hex-head screws from
6.
the top hinge and remove the hinge.
Remove the 2 front and 2 rear screws from the
7.
cabinet top.
Condenser
To remove the condenser:
Unplug ice maker or disconnect power.
1.
Tip the front of the cabinet back and prop it up.
2.
Remove the 4 condenser fan motor screws from
3.
the fan motor shroud. Pull the motor assembly
back away from the condenser as far as
possible, but do not remove it.
Remove the 2 mounting screws from the
4.
condenser bracket
fl
anges.
Access the sealed system and discharge the
5.
refrigerant into an approved recovery system.
Unbraze the 2 condenser joints from the tubing.
6.
(Continued next page)
