GE Moisture Image 1 Series, Programming Manual

Page: 52 / 125

Basic Programming 2-33
April 2004
Setting Up a Box
Once you switch to the matrix format, you can assign the desired
channel, measurement modes and units to any of the boxes. Figure 3-
18 on page 3-31 for a menu map.
1. At the Main Menu, press the SELECT menu key. You are now in
the Select Menu.
2. Press the PAGE menu key. At the Display Page # prompt, enter
the page number and press [YES].
3. Press the MODE menu key. A list of measurement modes appears
on the message line (see Table 2-6 on page 2-31).
4. Press the PLACE menu key to move the larger pointer to the box
you want to change.
5. Move the brackets to the desired measurement mode and press the
UNITS menu key. A list of measurement units appears on the
message line.
Note: To clear (unassign) a box, press [NO]. The Series 1 labels the
box X Unassigned (see Figure 2-17).
6. Move the brackets to the desired measurement units and press
[YES].
7. Enter the desired channel number.
Note:
A “Channel Not Installed” message appears if you select a
channel where no channel card is installed. Select a different
channel. The meter will emit a buzzing sound.
Repeat the above steps for each desired box. To exit, press the DONE
menu key until Main Menu appears on the message line.