KTC-XP1 UltraView Camera
Installation
1047441A / February 2004
9
2.4 M
AKING
P
OWER
C
ONNECTIONS
CAUTION:
y
Use direct plug-in UL listed power supplies marked Class 2 or
LPS (limited power source) of the required output rating as listed
on the unit.
y
Complete all instruction steps before supplying power to the unit.
See Figure 5 and perform the following:
Connect a universal
12 VDC/24 VAC power
supply as shown
Note:
The terminal block is not
polarity-sensitive.
Note:
The power LED (
)
illuminates to show that the
camera is receiving power.
Figure 5. Power connections
1)
With a screwdriver, loosen the ~AC24V/DC12V and GND terminal
screws on the terminal block.
2)
Connect
a universal 12 VDC/24 VAC
power supply to the terminal block.
Note:
The terminal block is not polarity-sensitive. Either power lead can be
connected to either terminal connector.
3)
Retighten the terminal screws until snug, ensuring that the power
leads are secure.
4)
Supply power to the unit by plugging the power supply into a proper
power source.
Note:
The power LED ( ) illuminates to show that the camera is receiving power.
If it does not illuminate, check the terminal block connections and the power source.
Summary of Contents for KTC-XP1
Page 1: ...KTC XP1 UltraView Camera With Xposure Technology ...
Page 24: ......
