GE iVent 201 1.4, User'S Reference Manual

Page: 44 / 290

32
INTRODUCTION
This section shows you how to set up the iVent
TM
201, and includes the following:

Connecting to external AC or DC power

Using the internal battery

Verifying power condition

Charging the battery, and proper recharging procedure

Connecting to cylinder, central supply-system, or low-pressure oxygen

Connecting the breathing circuit

Installing heated humidification

Connecting a pneumatic nebulizer

Connecting a pulse oximeter

Installing filters at the ventilator’s inlet and outlet

Packing the unit in its optional transportation case
POWER CONNECTION
EXTERNAL POWER
The iVent
TM
201 can use either external alternating current (AC) or direct current
(DC) power. Both AC and DC inputs are located on the back panel of the
ventilator (see Figure 5). A hospital grade AC power cord is supplied
CAUTION Before connecting the ventilator to an AC or DC outlet, verify that the
external power supply is the correct voltage and frequency.
NOTE When connecting to an external battery use P/N M1162000
Connect one end of the AC or DC cord to the ventilator and the other to the
power outlet
WARNING To prevent electrical shock hazards, connect the power cord to a
properly grounded power outlet.