3.3.2 Battery page
The
Battery
page shows the following information.
Parameter Name
Description
Battery Status
The current status of the battery:
1 – unknown
2 – normal The remaining run-time on batteries is greater than
the UPS low battery time (ref.
UPS Config
page)
3 – low
The remaining run-time is less than or equal the UPS low
battery
time
(ref.
UPS Config
page)
4 – depleted The battery would be unable to sustain the load, if mains
power is lost
Seconds On Battery
The time elapsed since the UPS switched to battery power (in seconds)
Estimated Minutes Remaining
An estimate of the remaining run-time on batteries, under present load
conditions (in minutes)
Estimated Charge Remaining
An estimate of the remaining battery charge (in percentage – 100% is full
charge)
Battery Voltage
The present battery voltage (in Volts)
Battery Current
The battery flowing from/to the battery (in Amperes)
Battery Temperature
The ambient temperature of the UPS batteries (in °C)
Battery Ripple
The RSM ripple on the DC link (in Vrms)
3.3.3 UPS Status page
The
UPS status
page shows the following information for each of the input / output / bypass lines.
Parameter Name
Description
Frequency
Line frequency (in Hertz)
Voltage
Line RMS voltage (in Volts)
Current
Line RMS current (in Amperes)
Power / True Power
Line True Power (in Watt)
Load %
The power capacity presently being used (percentage)
[Output only]
Volt min
Lowest input voltage in the present time-period (in Volts)
[Input only]
Volt max
Lowest input voltage in the present time-period (in Volts)
[Input only]
Also the following information is presented:
Parameter Name
Description
Input Line Bads
Number of times the mains input went out-of-tolerance since UPS start-up
Output Source
The present source of the output power
Note:
none
means there is no output power
Modifications reserved
Page 29/69
OPM_CNT_SNM_BAS_CRD_1GB_V014.doc
Operating Manual
SNMP/Web Adapter
