GE D20MX, User Manual

Page: 111 / 146

APPENDIX D: USING CONFIGPRO WITH D20MX
D20MX HARDWARE USER’S MANUAL GE INFORMATION 111
3.5.1. Use the memory model settings from the factory default configuration as
a reference, See the table below.
3.5.2. Manually set the memory model in the D20MX device being modified by
selecting the Processor tab > Memory Model tab > Set Manually option.
NOTE
Step 3.6 is applicable if the device configuration were a “LAN-based Device”
configuration. LAN-based device in the device properties must first be selected under
the main General tab. It is impossible to have a LAN-based device unless the project
itself is a LAN-based project with all network addresses and settings clearly defined
for LAN A and/or B. Step 3.6 assumes that the reader is familiar with the complete
ConfigPro LAN settings configuration steps and that these steps have already been
considered. It points out the D20MX factory default LAN-settings.
3.6.
Set the LAN Settings.
Default LAN-Based Important Settings : Notice that the D20MX factory
default configurations are LAN-based. This is because the hardware of the
D20MX RTU has built-in LAN functionality by default. Subsequently, no extra
Media Interface Card or EME card is needed.
3.6.1. For LAN-based D20MX configurations, ensure that the
BOOTP Settings
option is disabled; select the Not Used option.
D20MX Processor Memory Model - Set Manually
EPROM Base
60000000 [HEX] EPROM Size 10000000 [HEX]
NVRAM Base 50010000 [HEX] NVRAM Size 00FF0000 [HEX]
RAM Base 00000000 [HEX] RAM Size 40000000 [HEX]