17
Disarming your system
When to disarm
If the area you want to enter is armed, you must first disarm the alarm system before you can enter, otherwise
you will set off the alarm. You will know which area is armed because its LED on the keypad will be lit red.
If the screen saver is enabled, only the Mains LED will be lit. Once a valid code is entered, the system status
will be shown.
The time limit when disarming
On entering the area, the system will allow you a preset time to disarm before an alarm occurs.
Disarming when there is an alarm
If there is an alarm condition when you are disarming the system, the alarm is reset. You must then find out
what caused the alarm and fix it. Use the function "Listing past alarm events" to get a list of all the alarms that
recently have happened (see page
In case of a voice module being installed and programmed, during disarm from an alarm the text "Stop Voice
Reporting" can be displayed. This option will stop the reporting of a voice message triggered by the alarm
when accepted by pressing the
[ENTER]
key.
When you cannot disarm
You might not be authorised to disarm specific areas in the premises. See the earlier section "
When you cannot
arm/disarm
" on page
for more information.
To disarm the system
1. Before commencing, if there is no alarm in the area, the display must show:
14:10
11/01/2005
Code:
2. Enter your PIN code.
3. Press
[OFF]
.
4. The result of step 3 depends on whether the system has been programmed to display a list of the areas
assigned to your PIN.
Areas not displayed:
If your system has not been programmed to display a list of the areas assigned to your PIN, all armed areas are
now automatically disarmed (provided all zones were normal). The display returns to that shown in step 1.
Areas displayed:
If a list of the areas assigned to your PIN is displayed, all armed areas are now listed, for example:
0-All 1, Office 2, Boardroom 3, Workshop
Enter Area:
From this display you have several options:
