GE HEALTHCARE E-PSMP, Technical Manual

Page: 581 / 622

Patient Data module
16 - 17
2062973-004
Impedance respiration:
•
Configure impedance respiration settings as follows:
Baseline impedance :1000 Ω
Amplitude : 1
Ω
Respiration rate : 20 breaths per minute
Lead selection : II (or LL)
Invasive pressure:
•
Configure the simulator’s P1, P2, P3 and P4 invasive pressure channels to 0 mmHg static
and atmosphere pressure.
Temperature:
•
Configure the simulator’s temperature channels as follows:
Temperature : 37°C/98.6°F
Defib/sync and analog output:
•
Configure the settings as follows:
Heart rate : 80 bpm
Amplitude : 1.0 mV
3.3.2 ECG tests
1. Normal Sinus Rhythm
a. Check that the monitor displays the ECG leads II, VI & aVL and the waveforms are
noise-free. The monitor shall display a 80± 5 bpm heart rate and an audible QRS tone
sounds with each QRS complex.
NOTE: If necessary, turn up QRS volume.
b. Select the All ECG Waveforms view from the ECG Setup tab in the ECG menu. Check
that all 12 ECG leads are available and they are noise free.
c. Close the All ECG Waveforms view.
2. Pacemaker Detection
a. Configure the simulator to show “Asynchronous Pacemaker Pulse”
b. Check that pacemaker spikes are shown on the ECG waveform.
c. Configure the simulator to show
“80 beats per minute, Normal Sinus Rhythm”.
3. Asystole Detection
a. Configure the simulator to show “Asystole”.
b. Check that the ‘Asystole’ alarm appears on the monitor screen.
c. Configure the simulator to show
“80 beats per minute, Normal Sinus Rhythm”.
4. Leads Off Detection
a. Detach the RA/R leadwire from the simulator.
b. Check that the Lead II waveform disappears from the ECG1 waveform field, followed
by an “RA/R lead off” message.
c. Check that Lead II is replaced by Lead III in the ECG1 waveform field after a while.
d. Reconnect the RA/R leadwire to the simulator.
e. Check that Lead III is replaced with Lead II in the ECG waveform field.
5. Mark this task as complete on the checkout form.