GE HEALTHCARE E-PSMP, Technical Manual

Page: 42 / 622

Module Frames and Modules
2 - 28
2062973-004
3.4.4 Invasive pressure tests
Perform the following test steps to both to the P1 and to the P2 invasive pressure channels.
NOTE: The ‘x’ in the PX refers to the invasive pressure channel being tested.
9.
Zeroing
a.
Ensure that the simulator InvBP output channel is configured to " 0 mmHg static
pressure" or "atmosphere"
b. Zero the tested invasive pressure channel by pressing the related
Zero Px
module
key.
c. Check that a message "Zeroing" followed by a message "Zeroed" is shown in the Px
parameter window.
10. Static Pressure
a. Configure the simulator's InvBP output channel to "200 mmHg static pressure".
b. Check that the flat pressure line appears on the related waveform field. The reading
in the parameter window shall be 200 ±10 mmHg.
NOTE: Recalibration is needed, if the measured value is not within the specification limits.
Calibrate the invasive pressure channels according to the instructions in
4.1. Invasive pressure
calibration ” section.
11. Pressure Waveforms
a. Configure the simulator's InvBP output channel to "Arterial 120/80".
b. Check that the pressure waveform for tested invasive pressure channel appears in
the Px waveform field and the Sys/Dia (Mean) pressure values are shown in the
related parameter window.
12. Mark this task as complete on the checkout form.
3.4.5 Temperature tests
Perform the following test step both to the T1 and to the T2 temperature channels.
NOTE: The 'x' in the Tx refers to the temperature channel being tested
13. Temperature test
a. Check that reading in the Tx temperature channel is 37 ± 0.1 °C and that no error
messages are shown.
NOTE: Recalibration is needed, if the measured value is not within the specification limits.
Calibrate the temperature channels according to the instructions in
4.2. Temperature
calibration ” section.
NOTE: You can alternatively perform the above test using a "temperature test set", P/N
884515-HEL. Test each temperature channel with both test plugs. The reading in the Tx
temperature channel shall be within
±
0.1°C of the nominal value.
b. Mark this task as complete on the checkout form.
3.4.6 SpO2 tests
14. SpO2 test
a. Connect the SpO2 finger probe to your finger. Wait until a pulse is found.