GDS 630P I Range, Installation And Maintenance Manual

Page: 10 / 17

10
The diagram below (Figure 2) corresponds to what is shown on the keypad of the SEW variable speed drive
(this keypad is removable).
Figure 2.
Function Factory Settings

Acceleration ramp time 5 sec

Deceleration ramp time 4 sec

Maximum speed 4000 rpm (For 750's = 640mm/sec, for 550's = 490mm/sec)

Opening Speed 3640 rpm (For 750's = 580mm/sec, for 550's = 440mm/sec)

Opening and closing slow speed 600 rpm (For 750's = 100mm/sec, for 550's = 75mm/sec)

Closing Speed 3000 rpm (For 750's = 480mm/sec, for 550's = 360mm/sec)

The motor start-up function has been pre-set in the factory and should not need altering
Parameter Settings
Par Nxx

Pt 39 Input Status

Pt 59 Output Status

Pt 80 Fault memory (records the previous faults which occurs with the inverter)

Pt 136 PE stop time (0.5 s)

N11 Opening speed (3640 rpm)

N13 Closing speed (3000 rpm)

N21 When set to formulae and powered off and on will reinitialise the gate

N22 Pedestrian opening position (% of full opening position max 80%)

N23 Opening and closing slow speed (600 rpm)

Pt 400 Gate counter, maximum 5000 (500,000 operations) Note. 100 gate
operations will be recorded as 1 on the inverter counter).

Pt 401 Internal serial number for recalibration

Pt 450 low current setting (usually 60 %)