GDS 630P I Range, Installation And Maintenance Manual

Page: 16 / 17

16
WARNING!
Failure to maintain equipment may result in injury or death and/or damage to property and equipment
Recommended maintenance to be performed on the operator and gate are as follows:-
Operator performs over 150 cycles a day each month
Operator performs between 100-150 cycles a day every 2 month
Operator performs between 50-99 cycles a day every 4 months
Operator performs between 20-49 cycles a day every 6 months
Operator performs under 20 cycles a day every 12 months
Date: ..............................................................................................
Site Name:..........................................................................................................................................................
Site Address: ......................................................................................................................................................
Before commencing maintenance on the operator, isolate the electrical supply to ensure operator will not run
inadvertently.
Gate rolls freely when in manual.....................................................................................

Gate wheels and guide rollers in good condition.............................................................

Gate stops in good condition and not loose .....................................................................

Gate rack is tight & correct clearances between pinion wheel & rack ............................

Gate track is not damaged................................................................................................

Gate operator mounting bolts right..................................................................................

No oil leaks from gearboxes ............................................................................................

Gearbox mounting bolts/nuts tight ..................................................................................

Inside operator and control box clean..............................................................................

‘Baygon’ Surface Spray around operator and control box (not on electronics) ..............

All electrical connections tight ........................................................................................

Limit Switches operate in appropriate positions/ chain oiled..........................................

External safety devices work effectively / cleaned..........................................................

Electromagnetic lock, if fitted, operates correctly and is clean .......................................

Wash down of control box and cover (particularly near corrosive/sea environments)....

General operation i.e. speed, auto close etc normal ........................................................

Comments ............................................................................................................................................
..............................................................................................................................................................
..............................................................................................................................................................
Service performed by...........................................................................................................................
8
. M
AIN TE N AN CE
D
E TAI LS