GCC Technologies Jaguar IV Series, User Manual

Page: 37 / 166

Jaguar IV User Manual
The Control Panel 3-2
3.2 Menu in On-line Mode
Power On
Jaguar IV in processing
Jaguar IV
Firmware: Copyright:
Place Media And Then Lower
Down The Lever
Roll Edge Single
Sizing Media Width Lever Up
To Abort
Sizing Media Length Lever Up
To Abort
Pause Setup Resume
S--- F----- O----
L-------- W-----T1M
Sending data
[
PAUSE
]
[ FORCE] Force:80 gf
OK:ENTER
use to select; [ENTER] to enable the setting
[ SPEED ]
Speed: 72 cm/s
Select: OK:ENTER
UP Speed: 72 cm/s
Select: OK:ENTER
Quality: normal
Select: OK:ENTER
[ OFFSET ] Offset: 0.275 mm
OK:ENTER
[ DATA CLEAR ]
Clear Data Memory
N:Cancel OK:ENTER
[TOOL SELECT ]
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Pouncing 0 mm
Select:
OK:ENTER
Top menu
Set Tangential Mode
Select: OK:ENTER
use to select
GCC Cutter
LCM Version- - -