GCC Technologies Jaguar IV Series, User Manual

Page: 55 / 166

Jaguar IV User Manua
l
Operation
4-12
To activate the Die Cut function, go to “Option”, tick “Die Cut”, and enter the amount you wish
for the “Length” and “Force” of both Die Cut and Kiss Cut, then click “OK” (see figure 4-20).
Figure 4-20
When the job is completed and you untick the Die Cut function, you will be able to adjust the
pen speed, pen force, and offset in the section on the top following normal operating
procedures (see figure 4-21).
Figure 4-21
*Note:
The length setting for the cutting line of
Die Cut is in the range of 0-2000mm
whereas that of Kiss Cut is 0-100mm.
Note:
1. The extension of the blade has to be set
to cut through both the top layer and the
backing in the very beginning. You then
adjust the tool force for the best cutting
performance.
2. Once the Die Cut function is activated, it
will perform on all the line segments on
the object.