GCC Technologies J4-101S, User Manual

Page: 40 / 130

Jaguar IV User Manua l
Make sure that the media
tension is equally distributed
from left to right. If the media
were not tightened enough
against the platen, it would
cause tracking problems!
Note :
Step 4
Turn the roll downward to make an equal tension
across the media (Figure 4-11)
Step 5
Move the pinch rollers to the appraise location and
note that the pinch rollers must be positioned above
the grid drums.
Step 6
Push the lever backward to lower down the pinch rollers.
Step 7
Fix roll media guide bushes on the roll holder to secure the roll media.
Step 8
Turn on the power switch, the tool carriage will sizing the media automatically.
Then the cutting plotter is ready to work.
Step 9
Use the reverse steps to remove the media.
4.2 Tracking Performance
In order to achieve the best tracking performance for a long plot, we recommend some
significant media loading procedures described as follows:
If the media length is less than 4 meters, leave the margin of 0.5mm
—
25mm in the left and right
edges of the media (Figure 4-12).
0.5mm - 25mm
0.5mm - 25mm
Pinch roller
Pinch roller
Figure 4-12
Operation
4-5