GCC Technologies J4-101S, User Manual

Page: 21 / 130

Jaguar IV User Manual
Installation
2-10
Figure 2-18
Figure 2-19
.5 Automatic Blade Length Adjustment
igure 2.-18 is the new blade holder with a scale and the carriage with a mark.
There are 10 units on the scale; each unit equals to 0.1 mm, allowing you to adjust the blade length
for 0.00mm-5.00mm (Figure 2-18).
Follow the steps below to adjust the length of the blade
1. Keep your blade length as 0 before you start adjusting.
2. Align one of the scales on the blade holder to the mark on the carriage
3. Select “Blade Length Adjust” under “CUT
” on the LCM, enter the blade length
wished in “Set Length”; test the blade holder first and then test the blade length by
pressing ENTER.
Note: Keep the blade holder at the same position when you perform blade holder and blade
ngth tests.
. When blade holder and blade length tests are finished, the screen will show you to what
hat you should turn the knob for half a circle clock-wisely
(Figure 2-20, Figure 2-21).
s perfect and no more adjustment needs
be made. You may start cutting at this point.
2
F
Scale
Mark
TEST
le
4
degree (the unit of the value following “CW” or “CCW” is “circle”) and in which direction
[CW (clockwise) or CCW (counterclockwise)] you should turn the adjustment knob.
EG, Turn CW 0.5 is telling you t
The value on the screen will be 0.0 when the blade length i
to