GCC Technologies Elite 21DN, User Manual

Page: 49 / 311

1-41
Additional Installation Notes
Configuring Startup Page
The Elite 21 printer will print a Configuration Page each time that the printer is started up. This page
serves as a hardware test at startup, to make sure that all printer systems are working properly and
that the printer is able to print a page successfully. This page also provides a listing of all user-
configurable printer parameters and their current settings, which can be useful in printer
troubleshooting.
Some users, especially those who restart their printer often, may wish to disable this page. The steps
for disabling the Startup Page are as follows:
• Make sure the printer’s display is reading “Ready.”
• Press Menu up or down until “Configuration” appears.
• Press Item up or down until “Startup Page” appears.
• Press Value up or down until “Disabled” appears.
• Press Select to accept the new setting.
• Press Menu up or down until the display returns to “Ready.”
The Startup Page will not print out the next time the printer is started.
Note:The factory default for the Startup Page is Enabled, so if the printer is reset to defaults using the
“Restore Defaults” feature in the Resets menu, the page will be re-enabled. Follow the steps above to
disable the page again in this case.
Location of Serial Numbe
r
When filling out the Product Registration card included with your printer, you will be asked for the
printer’s serial number. You can find the serial number as follows:
1. On the printer: The serial number is located either on a label at the bottom right of the printer’s rear
panel (near the power cord receptacle), or inside the printer. If no label appears on the rear cover,
check the internal label as follows:
• Switch off the power to the printer.
• Squeeze the latch at the upper left of the rear cover and pull it towards you to open the rear cover.
• At the bottom right of the printer’s interior, you will see a barcoded label with the serial number
printed below the barcode.
• Make note of the serial number and close the rear cover, making sure it latches completely.