Adjustments/Repairs
02-03-2017
GBC StreamPunch Ultra/Ultra MP
4-64
ARP 2.27 Stepper and Mount Assembly Replacement
PARTS LIST ON PL 2.6
Use this procedure to remove and install the Entrance Motor (M1), Accel
Motor (M2), Exit Motor (M6), Decel Motor (M7), or Bypass Motor (M8).
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Locate the affected Motor (see PL 2.6).
4. Disconnect the Motor Connector from the corresponding Motor Drrver
(PL 2.6).
5. Loosen the corresponding Timing belt tensioner by loosing (2) M4
nuts.
6. Remove the M4 Screws or nuts and the flat washer (4) and the
Stepper and Mount Assembly from the Rear Panel.
7. Place the Stepper and Mount Assembly in position and tighten the
Screws (4).
8. Adjust the corresponding belt tension per ADJ 1.4 Timing belt
adjustment procedure.
9. Connect the Motor Connector.
10. Do ARP 1.6 to install the Rear Cover.
11. Connect the Power Cord.
M8
M1
M2
M6
M7
Screws (4)
Washers (4)
Summary of Contents for StreamPunch Ultra
