GBC StreamPunch Ultra/Ultra MP
02-03-2017
Adjustments/Repairs
4-25
ARP 2.4 Acceleration Roller Idler Assembly Replacement
PARTS LIST ON PL 3.1, PL 3.3
Do the following to replace the Acceleration Idler Roller Assembly (or the
Accel Idler Panel Weldment).
Removal Procedure
1. Disconnect the Power Cord.
2. Do GP 6.3
Undock the Punch
to separate the Punch from the
upstream and downstream devices.
3. Open the Front Door.
4. Open the Acceleration Idler Roller Panel and remove the M4 screw
for ground strap.
5. Open the Cable Clamps to release the Sensor Cable.
6. Disconnect the Accel Sensor S5 Connector at the the sensor
7. Disconnect the Acceleration Idler Roller Solenoid SOL5 Connector at
the rear frame.
(Cont.)
Sensor S5
Connector
Solenoid SOL5
Connector
Acceleration Idler panel Handle
Cable
Clamps
Summary of Contents for StreamPunch Ultra
