GBC Falcon 60+ (-1), Operation And Maintenance Manual

Page: 40 / 64

40
I
TO UNWEB THE LAMINATOR
Unweb the laminator if you are
changing film widths, cleaning the
rollers or have finished using the
machine for the day.
1. Using the rear slitter, cut (1) the
output from the web (Figure 32).
2. Cut (2) remaining top film web
between the idler bar and heat
roller. PSA film, cut the release
liner too.
3. Cut (3) the film web between
the lower film supply and the
idler bar (Figure 32).
CAUTION: Be careful not to cut
any of the rollers!
4. Remove the safety shield and tilt
the feed table.
5. Gap the main rollers and pull
rollers.
6. Carefully grab hold of the web
(top and bottom film), from the
front operating position and pull
towards you (Figure 33).
7. Do not allow the adhesive side
of the film to contact the heat or
pull rollers.
CLEARING A FILM JAM (Wrap-up)
Film jams (wrap-ups) may occur if
the film is loaded backwards or if
the area at which film exits the
equipment is blocked. The film,
when jammed, wraps around the
heat rollers during webbing if a
threading card is not used or pull
rollers during operaton.
To clear a jam:
1. Immediately stop the laminator by
pressing STOP ( ).
2. Remove the safty shield and tilt
the feed table.
3. Set motor direction to reverse.
4. Use the footswitch to reverse
the web until the wrap up is
clear.
5. Raise the main roller and pull
rollers.
5. Manually guide the web from the
main rollers and pull rollers.
6. Once the film jam has been
cleared, lower the main roller
and pull rollers.
7. Refer to the section titled
START LAMINATING.
Fig. 32
Fig. 33
(2)
(2)
(3)
= PSA film or mount adhesive
(1)
Pull web
Preliminary
Copy