GBC Falcon 60+ (-1), Operation And Maintenance Manual, Page: 16 / 64

16
I
PRE-INSTALLATION
Before a Falcon 60+ (-1) Laminator
can be installed, ensure the
following requiremets are met;
1. Are door ways and hallways
wide enough for the laminator to
be moved to the installtion site?
2. Is there ample room for the
laminator?
– A work area must be
established that allows for
operation in both the front and
rear of the laminator and
provides space for efficient
material flow. (Figure 2)
3. Is the enviroment appropriate for
the laminator?
– The laminator requires a clean,
dust and vapor free enviroment
to operate properly.
– Avoid locating the laminator near
sources of heat or cold. Avoid
locating the laminator in the
direct path of forced, heated or
cooled air.
Air flow can cause
uneven heating/ cooling
of the rollers and result in
poor output quality.
4. Have you contacted a certified
electrician to wire the receptacle
and ensure that adequate
power is being supplied, having
the appropriate capacty, over
current protection and safety
lockouts available?
– 220V at 60hz with 25 amp
service. Use the receptacle
supplied with your machine.
Fig. 2
20 ft.
( 508 ) cm
13 ft
( 330 cm )
3 ft
( 91 cm )
8 ft 8 in
( 220 cm )
8 ft 8 in
( 220 cm )
4 ft. x 6 ft.
(101.6 x 152 cm)
Work table on wheels
Electrical cord
drop
Front
Back
4 ft. x 6 ft.
(101.6 x 152 cm)
Work table on wheels
Preliminary
Copy