gAvilar gACC-499E/U, Manual

Page: 13 / 46

GA-02.035-EN-30.05.17
Page 13 of 46
gACC-499E/U Communication unit
gACC-499E_U_Manual_EN.doc
Note: The input of parameters is not case sensitive. For example
“y” or “Y” can be applied.
In determining times for the call windows the start-up time of the gACC-499E/U should be taken in to
consideration. It will take approx. 3 minutes before a dial-in can be performed.
Channel OBIS code
Parameter Factor Unit
A1 23.2.0 VN Volume converted 1 m3
A2 1:12.0.0 SVB Vol. measured at error 1 m3
A3 13.1.0 VB Vol. measured 1 m3
A4 1:13.0.0 VO Volume Encoder 1 m3
A5 0:41.0.0 T Gas temperature 10 K
A6 0:42.0.0 PABS Pressure gas 1000 mbar
A7 97.97.0 ALR1 Status information* gAVC1200 1 -
B1 1:13.0.0 VO Volume Encoder 1 m3
B2 C.91.10 Herst Manufacturer gas meter 1 -
B3 7-1:0.2.14 FabNo Serial no. gas meter 1 -
B4 C.91.11 HerstJahr Year of built gas meter 1 -
B5 97.97.0 ALR1 Status information* gAVC 1200 1 -
B6 1:13.0.0 VBZlastmonth Vb index end of month 06:00 hour 1 m3
The units for temperature and pressure can be adjusted from K and mbar to C and bar.
The IEC62056-21 will be automatically adjusted after changes the units.
This is irrelevant for the encoder application because there are no meter readings.
Channel OBIS code
Parameter Factor Unit
A5 0:41.0.0 T Gas temperature 1 C
A6 0:42.0.0 PABS Gas pressure 1 bar
B5 0:41.0.0 T Gas temperature 1 C
B6 0:42.0.0 PABS Gas pressure 1 bar
/protocol End of protocol. The order of the channels is defined in the table above.
uptime
hourstart="18"
minutestart="00" (at 18:00 hours the modem is switched on)
minutesduration="120" (The modem stays switched on for 120 minutes before dial-in)
upaftercallin="5" (After disconnecting the modems stays switched on for 5 minutes)
Note: The time set at “minutesduration’ can never be exceeded by “upaftercallin”
daylight="Y" (Summertime is enabled, with “N” it’s disabled
NoIntermediateGSM=”N” The TC65i module is enabled for data communication, with “Y”
only the internal measuring data will be moved to the system memory.
/dual2 End of the second block of the config file.
</configuration> Close configuration file