Gateway GT110 Series, User Manual

Page: 50 / 100

3 System upgrades
36
(2) Gently pull the DIMM upward to remove it from the socket.
4 If you intend to install a new DIMM, proceed to the next section,
otherwise observe the post-installation instructions described on page
23.
To install a DDR2 unbufferred DIMM:
1 Perform steps 1 through 3 of the previous section.
2 Select an empty DIMM slot.
3 If necessary, open the holding clips of the selected DIMM slot.
4 Remove the new DIMM from its protective packaging, handling it by
the edges.
5 Install the DIMM.
(1) Align the DIMM so that the notch on the slot fits the keyed edge of
the module, then press the module at both ends to seat it fully into
the slot.
If you insert an DIMM but it does not fit easily into the slot, you
have inserted it incorrectly. Reverse the orientation of the module
and insert it again.
(2) Firmly press the holding clips inward to lock the DIMM in place.