Gateway 910 Series, System Manual

Page: 92 / 129

84
Troubleshooting
Video problems
The server is running but the screen is blank
The image on the screen is dim or difficult to read
Probable cause Solution
The monitor is not turned on Make sure the monitor is plugged in and turned
on. If the monitor is turned on, the green power
LED should illuminate.
The monitors data cable is
not connected Make sure the monitor data cable is connected
to the video controller on the back of the
server.
The connector or cable is
damaged Check the connector and cable for bent or
damaged pins.
The monitor is defective Connect a working monitor to the server.
The monitor brightness and
contrast controls are turned
down Adjust the brightness and contrast knobs to the
center position.
The DIMM is not seated
properly, indicated by a beep Open the server and reseat the loose the
DIMM.
Probable cause Solution
The monitor brightness and
contrast controls are turned
down Adjust the brightness and contrast knobs until
the text becomes clear.
Sunlight is glaring off the
display Position the monitor away from the sun or a
window.
The monitor may be old Replace the monitor.